WCB API600 CLASS300 Gate Valve GVC-00300
Quick Detail: WCB 300LBS Gate Valve, API 600
Design standard: ANSI B16.34
Body material: WCB.
Nominal diameter: 12”
Pressure: CL300LBS
End connection: RF FLANGE
Face to face: ASME B16.10.
BB OS& Y Design valve
Bi-Direction Gate Valve
Working temperature: -29℃~+425℃.
Mode of operation: handwheel
Test and inspection: API 598.
Body test pressure: 7.5Mpa
Seat Test Pressure: 5.5Mpa.
Products Range:
Available Material: Cast steel. A216WCB, WCC, LCB, LCC, SS.
Optional stem/shaft: A182F6a, SS304, SS316, SAF2507 SAF2205
Optional seal/Seat: STL, 2CR13, SS304, SS316 SDSS
Optional End connection: butt welding, RF, NPT, SW
Optional Operation: Gearbox, Electric, Pneumatic actuator
Range of the size diameter: 1/2″~60″ (DN15~DN1500).
Range of the Rating: 150lbs~2500lbs (PN16~PN420).
Customized Design is negotiable.
Performance:
Operation & Assembly
- Vertical orientation requirement of valves during operation, testing, and installation is prescribed to all gate valves.
- All gate valve operators must be assembled in the upright position vertically above the valve’s centerline.
- Gearboxes, actuators and necessary adapters must conform to the valve’s ISO pad top works design
- Adapter plates and gears must be bolted to the valve top works plate using the correct bolt size, torque, and tightening pattern.
- The stem must be protected at all times from unnecessary movement, stress, force or other potential damage while ensuring the stem remains centered in the yoke tube during installation
- Automation mechanisms must be designed, assembled, and supported in a manner as to not exert
- uneven or unbalanced forces on the valve assembly that could contribute to a side load condition.
Available Material: Cast steel. A216WCB, WCC, LCB, LCC, SS.
Optional stem/shaft: A182F6a, SS304, SS316, SAF2507 SAF2205
Optional seal/Seat: STL, 2CR13, SS304, SS316 SDSS
Optional End connection: butt welding, RF, NPT, SW
Optional Operation: Gearbox, Electric, Pneumatic actuator
Range of the size diameter: 1/2″~60″ (DN15~DN1500).
Range of the Rating: 150lbs~2500lbs (PN16~PN420).
Customized Design is negotiable.
Operation & Assembly
-Vertical orientation requirement of valves during operation, testing, and installation is prescribed to all gate valves.
- All gate valve operators must be assembled in the upright position vertically above the valve’s centerline.
- Gearboxes, actuators and necessary adapters must conform to the valve’s ISO pad top works design
- Adapter plates and gears must be bolted to the valve top works plate using the correct bolt size, torque, and tightening pattern.
- The stem must be protected at all times from unnecessary movement, stress, force or other potential damage while ensuring the stem remains centered in the yoke tube during installation
- Automation mechanisms must be designed, assembled, and supported in a manner as to not exert
- uneven or unbalanced forces on the valve assembly that could contribute to a side load condition.
petroleum, chemical, Stem, Oil, Gas, Construction, pharmaceutical, light textile, electric power,
