GGG50 Check Valve CV-A-11
Quick Detail
Design standard: DIN3202 F6
Body material: ductile iron
Shaft: stainless steel 304
Body seat: Stainless steel welded overlay finish, micro finished
Disc Seat: EPDM
Nominal diameter: DN200 8″
Pressure: PN10 PN16
End connection: RF. Flange EN1092-1
Face to face: EN558-1/8
Working temperature: -40℃~+100℃.
Test and inspection: EN12266-1
Epoxy Powder coated inside and outside
EN 10204 3.1 with each delivered valve
Available Body Material: Cast Iron GG25, Ductile iron GGG40, GGG50
Optional body Seat Ring: SS304, SS316, SS316L, Bronze
Optional Seat Ring: EPDM, NBR, PTFE.
Optional Design: DIN /BS/ ANSI with difference Face to face length
Optional Ends: BS4504/EN1092-1 PN16/ ANSI B16.5 RF
Size Range: DN50-DN600 (2″-24″)
Pressure Range: PN10, PN16, PN20(150LBS)
Optional surface color: RAL5002, RAL5015. RAL5005, red, black. Or customized
•Silent Check Valve is used as protection against reverse flow when power failure in areas where noise pollution or water hammering is a critical issue. It can provide not only quiet performance but also low head loss.
•High strength ductile iron body used for durability and less weight.
•Advanced dynamic design of single body with diffuser provides streamline flow and assures lower head loss.
•One of the lowest head loss check valve, big save in pumping power cost, valve disc with shorter stroker and spring reverse faster than most of check valve.
•Coated with powder epoxy both inside & outside for corrosion resistance.
•Bronze bushing reduce wearing problem during operation.
•Hydrodynamic design with spring ensures non slamming and water hammerless.
•Stainless steel spring hidden in the diffuser under protection while valve in operation.
•Disc will positively close before reverse flow, and maximize the closing speed up to 0.2 Sec.
• Installation can be vertical/horizontal/inclined.
•Comply with EN 558-1, ISO 5752 and EN 1092-2, ISO 7005-2 flange dimension.
Dams & hydropower, Irrigation, Water treatment
